• No products in the cart.

[Live Webinar] Inspection and Testing for Cathodic Protection Systems

Intended Audience: Civil, Electrical & Mechanical Engineers
Credits: 2 PDH Units
When: Tuesday 10/4. 2 – 4 pm EST


This discussion includes criteria and inspection actions that, when used either separately or in combination, will indicate whether adequate cathodic protection of a metallic piping system has been achieved. The effectiveness of cathodic protection or other corrosion control measures can be affirmed by visual observation, measurements of pipe wall thickness, or by use of internal inspection devices. Because such methods sometimes are not practical, meeting any criterion or combination of criteria in this chapter is evidence that adequate cathodic protection has been achieved. When excavations are made for any purpose, the pipe should be inspected for evidence of corrosion and/or coating condition. Apply sound engineering practices to determine the methods and frequency of testing required to satisfy these criteria. The criteria in this discussion have been developed through laboratory experiments and/or verified by evaluating data obtained from successfully operated cathodic protection systems. Situations may exist where a single criterion for evaluating the effectiveness of cathodic protection may not be satisfactory for all

Date:  Tuesday. October 4. 2022.  Starts: 2 – 4 pm EST/EDT
Credits: 2 PDH Units

Learning Objectives

At the successful conclusion of this webinar, you’ll be able to identify and discuss:

  • Learn about the National Association of Corrosion Engineers (NACE) standards;
  • Learn about the importance of negative cathode potential;
  • Learn how to inspect and test bare or ineffectively coated pipelines where long line corrosion activity is of primary concern;
  • Learn how aluminum may suffer from corrosion under high pH conditions;
  • Learn the fundamentals of inline inspection of pipes;
  • Learn about stray currents and stray electrical gradients;
  • Learn how to test for a short between two structures with cathodic protection on one structure;
  • Learn when you should test for a short between two structures without cathodic protection on either structure;
  • Learn the current requirement testing procedures;
  • Learn about the use of temporary anodes; and
  • Learn about anode bed inspection and testing for impressed current cathodic protection systems.

Special Webinar Instructions

After payment, please visit this webinar page, click “Start Course” and fill out the Webinar Registration Form.  You’ll receive email notification and details on how to join the webinar.  You will then be able to access the webinar slides, test your system and receive webinar reminders.  After completing the webinar requirements, your certificate of completion will be saved and available for download in your profile.

We value your feedback! Please rate this webinar after completion.

Group Discounts Available

Course Reviews


2 ratings
  • 5 stars1
  • 4 stars1
  • 3 stars0
  • 2 stars0
  • 1 stars0
  1. Cathodic Protections Systems


    It was very technical and informative.

  2. Cathodic Protection Systems


    A lot of material. It would have been helpful to discussed some cases studies where engineering analysis and decision making was required.

  • $99.00
  • Average Rating4.5
  • Webinar No: WBNR 1169
  • PDH Units: 2

Once completed, your order and certificate of completion will be available in your profile when you’re logged in to the site.

Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA