Setup Menus in Admin Panel

  • No products in the cart.

Profile Photo
  • Course No E – 1841
  • PDH Units: 2

Course No E - 1841
PDH Units: 2
$75.00

Profile Photo
  • Course No E – 1841
  • PDH Units: 2

Course No E - 1841
PDH Units: 2
$75.00

Intended Audience: Civil & Structure Engineers.

PDH UNITS: 2

The use of composite members, connections, and systems is widespread.  Nowadays, almost all steel structures of buildings and steel girder bridges have composite floor decks supported on composite beams and girders. The columns in many buildings, especially in medium-, and high-rises, are also composite.  Concrete-filled tube composite piles are very popular these days because of their cost-efficiency and the ease and speed of construction.   Yet, the behavior and design of steel-concrete composite structures and their members and connections are not covered extensively, if at all in structural engineering curriculum.  The webinar presents information on the basic design of steel-concrete composite structures.  The webinar covers the basics of the following topics:

  1. Introduction to Composite Structures and Design
  2. Material Properties of Steel and Concrete in Composite Structures
  3. Shear Connectors in Composite Structures
  4. Composite Structural Framing Systems
  5. Composite Tension Members
  6. Composite Compression Members
  7. Composite Beams
  8. Composite Members under Combined Loads
  9. Composite Trusses
  10. Composite Shear Walls
  11. Types of Composite Connections
  12. Composite Shear Connections
  13. Composite Moment Connections

Learning Objectives

Upon completion of the Webinar, the student should understand:
  • The basic design of composite building structures.
  • Material properties of steel and concrete used in composite structures.
  • The design of “shear connectors,” which are the essential component of composite structures.
  • Common types of composite structural systems used in buildings.
  • Design of composite members subjected to axial tension or compression such as bracing members, columns, and piles.
  • Design of composite flexural members such as beams and trusses.
  • Design of composite members subjected to combinations of axial load, bending, shear, and torsion.
  • Design of composite shear walls
  • Basic types of composite connections.
  • Design concepts for most common composite shear connections
  • Design concepts for most common composite moment connections.

Join us this Thursday afternoon for a special Engineering Structure webinar:
Dos & Don’ts In Steel And Connection Design.
Starts 2pm ET
https://www.pdhsource.com/course/live-webinar-dos-donts-in-steel-and-connection-design/

We have put together our favourite #Engineering themed #podcasts for you. You're welcome 😉 #fridayfeeling https://www.borntoengineer.com/resources/top-engineering-podcasts-stem-podcast-list-top

ACCEPTANCE GUARANTEE


ncees

PDH Source engineering courses & live webinars meet NCEES Guidelines for Professional Engineer licenses renewal in all 50 states.

PDH Source will refund your money if the PDH credits you earn are rejected by your state board for any reason.

top
Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA