Setup Menus in Admin Panel

  • No products in the cart.

3
Profile Photo
  • Course No E – 1321
  • PDH Units 3.00

Course No E - 1321
PDH Units 3.00
$75.00

3
Profile Photo
  • Course No E – 1321
  • PDH Units 3.00

Course No E - 1321
PDH Units 3.00
$75.00

Intended Audience: civil engineers and other design and construction professionals

PDH UNITS: 3

This course provides an introduction to drainage pipe strength, cover and bedding. A drainage pipe is defined as a structure (other than a bridge) to convey water through a trench or under a fill or some other obstruction. Materials for permanent-type installations include non-reinforced concrete, reinforced concrete, corrugated steel, asbestos-cement, clay, corrugated aluminum alloy, and structural plate steel pipe. Course Outline 1. INTRODUCTION 2. SELECTION OF TYPE OF PIPE 3. SELECTION OF N VALUES 4. RESTRICTED USE OF BITUMINOUS-COATED PIPE 5. MINIMUM COVER 6. CLASSES OF BEDDING AND INSTALLATION 7. STRENGTH OF PIPE 8. RIGID PIPE 9. FLEXIBLE PIPE 1O. BEDDING OF PIPE (CULVERTS AND STORM DRAINS) This course will give you guidance you can apply when designing drainage systems using buried pipes and conduit.

Learning Objectives

At the successful conclusion of this course, you’ll be able to identify and discuss:
  • Learn about the strength and functional characteristics of different types of drainage pipe available commercially;
  • Learn guidelines for selection of an appropriate coefficient of roughness (“n”) for different types of drainage pipe;
  • Learn minimum cover recommendations for different types of drainage pipe;
  • Learn maximum cover recommendations to avoid the possibility of crushing underground pipe and conduits;
  • Learn the different classes of bedding for underground pipe and conduits;
  • Learn the strength properties of rigid and flexible conduit and pipe materials; and
  • Learn about bedding for culverts and storm drains..

Course Reviews

3

3
1 ratings
  • 5 stars0
  • 4 stars0
  • 3 stars0
  • 2 stars0
  • 1 stars0

No Reviews found for this course.

Join us this Thursday afternoon for a special Engineering Structure webinar:
Dos & Don’ts In Steel And Connection Design.
Starts 2pm ET
https://www.pdhsource.com/course/live-webinar-dos-donts-in-steel-and-connection-design/

We have put together our favourite #Engineering themed #podcasts for you. You're welcome 😉 #fridayfeeling https://www.borntoengineer.com/resources/top-engineering-podcasts-stem-podcast-list-top

ACCEPTANCE GUARANTEE


ncees

PDH Source engineering courses & live webinars meet NCEES Guidelines for Professional Engineer licenses renewal in all 50 states.

PDH Source will refund your money if the PDH credits you earn are rejected by your state board for any reason.

top
Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA