Setup Menus in Admin Panel

  • No products in the cart.

Profile Photo
  • Course No E – 1115
  • PDH Units 3.00

Course No E - 1115
PDH Units 3.00
$75.00

Profile Photo
  • Course No E – 1115
  • PDH Units 3.00

Course No E - 1115
PDH Units 3.00
$75.00

Intended Audience: hydrologists, civil engineers, hydraulic engineers, highway engineers and environmental engineers

PDH UNITS: 3

A weir is basically an obstruction in an open channel flow path. Weirs are commonly used for measurement of open channel flow rate. A weir functions by causing water to rise above the obstruction in order to flow over it. The height of water above the obstruction correlates with the flow rate, so that measurement of the height of the flowing water above the top of the weir can be used to determine the flow rate through the use of an equation, graph or table. The top of the weir, which is used as the reference level for the height of water flowing over it, is called the crest of the weir. Weirs are typically classified as being either sharp-crested or broad-crested. This course is devoted to the more widely used sharp-crested weir. The major emphasis is on the calculations used for flow rate over various types of sharp-crested weirs. There is also information about guidelines for installation and use of sharp-crested weirs. This course is intended for hydrologists, civil engineers, hydraulic engineers, highway engineers and environmental engineers. An attendee of this course will gain knowledge about calculations and installation & measurement guidelines for sharp-crested weirs as used to measure flow rate in open channels. Upon completing this course, the student will be prepared to study additional open channel flow measurement topics.

Learning Objectives

At the conclusion of this course, you’ll be able to:
  • Understand standard terminology used in connection with sharp-crested weirs for open channel flow measurement.
  • Apply the Kindsvater-Carter equation to calculate the flow rate over a suppressed rectangular weir for given head over the weir and weir dimensions.
  • Assess the conditions required to correctly use the Francis equation, as opposed to the Kindsvater-Carter equation, to calculate the flow rate over a suppressed rectangular weir and over a contracted rectangular weir for a given head over the weir and weir dimensions.
  • Analyze the conditions required in order to use the Cone equation, Q = 2.49 H2.48, to calculate the flow rate over a V-notch weir for given head over the weir and weir dimensions.
  • Use the Kindsvater-Shen equation to calculate the flow rate over a V-notch weir for notch angles other than 90o, given head over the weir and weir dimensions.
  • Determine whether required conditions are met and make calculations of flow rate over a cipolleti weir for given head over the weir and weir dimensions.
  • Evaluate the installation and use guidelines for sharp-crested weirs for open channel flow measurement.

Join us this Thursday afternoon for a special Engineering Structure webinar:
Dos & Don’ts In Steel And Connection Design.
Starts 2pm ET
https://www.pdhsource.com/course/live-webinar-dos-donts-in-steel-and-connection-design/

We have put together our favourite #Engineering themed #podcasts for you. You're welcome 😉 #fridayfeeling https://www.borntoengineer.com/resources/top-engineering-podcasts-stem-podcast-list-top

ACCEPTANCE GUARANTEE


ncees

PDH Source engineering courses & live webinars meet NCEES Guidelines for Professional Engineer licenses renewal in all 50 states.

PDH Source will refund your money if the PDH credits you earn are rejected by your state board for any reason.

top
Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA