Setup Menus in Admin Panel

  • No products in the cart.

Profile Photo
  • Course No E – 1351
  • PDH Units 5.00

Course No E - 1351
PDH Units 5.00
$125.00

Profile Photo
  • Course No E – 1351
  • PDH Units 5.00

Course No E - 1351
PDH Units 5.00
$125.00

Intended Audience: civil engineers, structural engineers, mechanical engineers, electrical engineers and other design and construction professional

PDH UNITS: 5

This discussion includes criteria and inspection actions that, when used either separately or in combination, will indicate whether adequate cathodic protection of a metallic piping system has been achieved. The effectiveness of cathodic protection or other corrosion control measures can be affirmed by visual observation, measurements of pipe wall thickness, or by use of internal inspection devices. Because such methods sometimes are not practical, meeting any criterion or combination of criteria in this chapter is evidence that adequate cathodic protection has been achieved. When excavations are made for any purpose, the pipe should be inspected for evidence of corrosion and/or coating condition. Apply sound engineering practices to determine the methods and frequency of testing required to satisfy these criteria. The criteria in this discussion have been developed through laboratory experiments and/or verified by evaluating data obtained from successfully operated cathodic protection systems. Situations may exist where a single criterion for evaluating the effectiveness of cathodic protection may not be satisfactory for all conditions. Often a combination of criteria is needed for a single structure. Course Outline 1. INSPECTION PROCEDURES AND CRITERIA 2. APPLICABILITY 3. CRITERIA 4. OTHER CONSIDERATIONS 5. ALTERNATIVE REFERENCE ELECTRODES 6. TESTING This course will give professional engineers and others an introduction to the principles and practices that are the basis of corrosion protection system testing and inspection.

Learning Objectives

At the successful conclusion of this course, you’ll be able to identify and discuss:
  • Learn about the National Association of Corrosion Engineers (NACE) standards;
  • Learn about the importance of negative cathode potential;
  • Learn how to inspect and test bare or ineffectively coated pipelines where long line corrosion activity is of primary concern;
  • Learn how aluminum may suffer from corrosion under high pH conditions;
  • Learn the fundamentals of inline inspection of pipes;
  • Learn about stray currents and stray electrical gradients;
  • Learn how to test for a short between two structures with cathodic protection on one structure;
  • Learn when you should test for a short between two structures without cathodic protection on either structure;
  • Learn the current requirement testing procedures;
  • Learn about the use of temporary anodes; and
  • Learn about anode bed inspection and testing for impressed current cathodic protection systems.

Join us this Thursday afternoon for a special Engineering Structure webinar:
Dos & Don’ts In Steel And Connection Design.
Starts 2pm ET
https://www.pdhsource.com/course/live-webinar-dos-donts-in-steel-and-connection-design/

We have put together our favourite #Engineering themed #podcasts for you. You're welcome 😉 #fridayfeeling https://www.borntoengineer.com/resources/top-engineering-podcasts-stem-podcast-list-top

ACCEPTANCE GUARANTEE


ncees

PDH Source engineering courses & live webinars meet NCEES Guidelines for Professional Engineer licenses renewal in all 50 states.

PDH Source will refund your money if the PDH credits you earn are rejected by your state board for any reason.

top
Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA